Replaces
Frequently bought together
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the blower motor resistor. This is a 2003 Honda Civic, and it's the same for 2001 to 2005, as well as other Honda models. You'll need a new blower motor resistor from 1AAuto.com, and a small Phillips screwdriver.
The blower motor resistor is located under the center of the passenger side dashboard. Remove the connector on the blower motor resistor. Remove the two Phillips head screws. Remove the blower motor resistor from the housing.
Here, we have our old part from the vehicle, and our new part from 1A Auto. You can see we have the same size part, same heat sinks. It's the exact same sized casing on the new part, so it's going to seal into your HVAC box, just like the factory piece did. What your blower motor resistor does is it changes how much power gets to the fan for your blower motor, which is how you get your variable fan speeds.
Some common symptoms of one of these going bad are certain fan speeds not working. If you lose number one, but two, three, and four still work, or one and two, and three and four still work, your blower motor resistor could be the cause.
As you can see, the new part from 1A Auto is going to bolt right in just like your original piece, direct fit, and fix you upright.
Reinstall your blower motor resistor into the box, the four pin connector, as the tab to lock in faces down. Install your two Phillips head screws. Use your stubby Phillips head screwdriver to put them back in tight. Reinstall your connector.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
Tools used
