Ignition Coil TRQ

1. step 1 : Beginning the Repair Jump to 0:05

   • This is Part 2 of a two part video
   • Please consult Part 1 for prior instructions
   • Perform the steps outlined in Part 1

2. step 2 : Installing the New Distributor Cap Jump to 0:33

   • Start the 1/4 inch bolts into the distributor cap
   • Push the distributor cap into place
   • Press the locating tab into place
   • Tighten the 1/4 inch bolts into the distributor cap
   • Connect the three distributor cap wiring harnesses

3. step 3 : Installing the New Spark Plug Wires Jump to 2:34

   • Match the new spark plug wires with the old ones of the same length
   • Use painter's tape and a marker to label each of the new spark plug wires
   • Label the new spark plug wires with the same number as on the matching old cables
   • One by one, attach the new spark plug wires to the distributor cap in the same position as the matching old wire
   • Route the number 8 wire to the spark plug at the back of the engine on the passenger side
   • Route the 2, 4, and 6 wires through their clips to their respective spark plugs
   • Route the driver side wires down the back of the engine
   • Connect the number 7 wire to the spark plug at the back of the engine on the driver side
   • Route the 1, 3, and 5 wires through their clips to their respective spark plugs

4. step 4 : Reattaching the Engine Cover Jump to 6:27

   • Put the engine cover into place
   • Insert the three T20 Torx screws into the engine cover

5. step 5 : Reconnecting the Battery Jump to 6:36

   • Reconnect the positive battery cable
   • Reconnect the negative battery cable

Tools needed for replacement

• General Tools

  Jack Stands

  Floor Jack

• Materials, Fluids, and Supplies

  Painter's Tape

  Marker / Writing Utensil

• Ratchets & Related

  Socket Extensions

  Ratchet

• Screwdrivers & Related

  Flat Blade Screwdriver

• Sockets - SAE

  1/4 Inch Socket

• Star Drivers & Sockets

  T20 Driver