Replaces
Part Details
This Ignition Kit comes with NGK Laser Iridium Spark Plugs and TRQ Ignition coils.
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Item Condition:
New
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Tools used
Take this cover off here. Just grab it in the front, and just pull it straight up and same in the back. Pull it straight up. This PCV hose I'm just going to remove the hose clamp. Just use some hose clamp pliers. Just grab the hose, twist it, pull it off. Just set that aside.
Just push down on this tab. Disconnect the connector, just slide it off, and take that bolt out. It's a 10 millimeter socket. Take that out. Just grab the coil and slide it up, straight up. Just make sure the spark plug tube is cleaned out. Use a little compressed air. It's all good.
Take the new coil, put a little dielectric grease in the end, just a little bit, and line it up. Take the bolt, get the bolt started, and we'll snug it up, and connect the connector. Lock it in place. We can torque this bolt to 62 inch-pounds. Then we are going to do the same with the other coils. This back coil, if you have to disconnect this hose to get it out of the way, just disconnect it just like we disconnected this hose. And take the hose, slide it back onto the PCV valve and put the hose clamp back in position.
Just take the cover, you can use a little bit of soapy water on the pins, help put the cover back in, and just line it up and push it down. You're good to go.
