Brake Caliper Service Kit 50 State Formula 12oz

1. step 1 : Making the Bleeder Bottle 0:51

   • Clean out a plastic bottle
   • Drill a 3/16 inch hole in a plastic bottle cap
   • Drill a small vent hole in the bottle cap
   • Feed two feet of 3/16 inch fuel line through the cap until it reaches the bottom of the bottle
   • Hold the fuel line to the cap with a zip ties on the inside of the cap
   • Fill the bottle partially with brake fluid
   • Twist the cap onto the bottle

2. step 2 : Filling the Brake Fluid 2:14

   • Clean off the brake master cylinder
   • Twist off the master cylinder cap
   • Fill the master cylinder with brake fluid
   • Twist on the master cylinder cap

3. step 3 : Bleeding the Brakes 2:51

   • Start with the wheel with the longest brake line
   • Fit the hose for your Bleeder Bottle onto the bleeder nozzle
   • Loosen the bleeder screw a quarter turn
   • Fully depress the brake pedal several times slowly
   • Pump the brake pedal until no air bubbles come out of the bleeder
   • Tighten the bleeder screw
   • Pinch the end of the bleed hose closed
   • Pull the bleeder hose off the bleeder nozzle
   • Add brake fluid to the master cylinder as needed
   • Repeat these steps moving from the remaining wheel with the longest brake line to the shortest
   • Check for a firm brake pedal feel
   • Fill the master cylinder again as needed
   • Dispose of waste brake fluid properly at your local parts store or junk yard

Tools needed

• Drill Bit Set

  Complete Metric Wrench Set

  Drill

  Wire Ties

  Rubber Vacuum Hose

  Cloth Rags