Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1AAuto. We've been selling auto parts for over 30 years! We're dedicated to delivering quality auto parts, expert customer service, and fast and free shipping, all backed by our 100% satisfaction guarantee. So visit us at 1AAuto.com, your trusted source for quality auto parts.
We're bringing our vehicle up on the lift to make it easier to show you what's going on, but you should be able to do this either with the vehicle on the ground or the front end raised slightly. We removed the wheel to make it easier to show you what we're doing, but you should be able to access this with the wheel on. We're going to use a T20 Torx driver. You can do this either as a screwdriver or with a ratchet, and remove the three T20 Torx bolts in each wheel well. Peel back the wheel liner, and there's a small access hole right here, where you can push in with the flat-blade screwdriver to release the tab, and then wiggle the side marker out of the bumper. Hold the light and rotate the side marker.
If you're replacing the bulb, simply pop the bulb out, and install a new one.
If you're replacing the side marker, once you've popped it off, pop the new one on, lay this back corner into the slot in the bumper, and then push the tab in until it locks in. Resecure your wheel well liner with your three T20 Torx screws.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
