Replaces
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
How are you doing? Mike from 1A Auto. Just going to show you how to remove and replace door handles on a 2015 Chevy Silverado, same as a Tahoe, Suburban, Yukons.
This is great. If you have black door handles, you can change to our chrome door handles, or if you just need to replace a door handle. If you're going to be working with the doors open, good idea, this switch right up here shuts off your dome light. Middle position is on with the doors open. Over here is permanently on. And then you can see the lights right here, shut it off, that way your lights aren't draining the battery while you're working on your door.
To remove your door handle, just remove this little rubber plug. Use a flat blade screwdriver or just pry it out of that hole. And then inside there, there's a seven-millimeter bolt. Then the seven-millimeter bolt, seven-millimeter socket with a ratchet and extension. Take a piece of duct tape and just lightly put it on here. That's going to help be able to have the bolt still stick in there. So go in at an angle, get it nice and tight on the bolt, and then remove it.
Now pull out on the door handle, and this piece, just kind of shake it and pull it out, and then the door handle, you can pull out, move it back, and the handle comes off.
You may want to clean where off the door handle goes. To reinstall the door handle, use a 90-degree awl, and put it in and up and over the lock. And then with the bent tip all in there, pull the mechanism, and then you can put your gasket on and put the front of the door handle back in, slide it forward and on. Make sure it's engaged.
Now pull the door handle out a little bit, put your rear piece in, and load up your seven-millimeter bolt in the socket with the tape. Push it in. You can look it in diagonally. Keep some pressure on the rear of the outside of the door handle, and with some good light, look the bolt into place and tighten it up. And put the rubber grommet back in place. And if you do happen to drop that bolt down in there, we have a video for removing the door panel, and you can remove the door panel and reach into the door and get it.
Thanks for watching. Visit 1aauto.com, your place for DIY auto repairs, for great parts, great service and more content.
