Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
In this video I'm going to show you how to replace the side parking lights, the front ones on 2002 Toyota Tundra. The only tools you'll need for this are a Phillips screwdriver and a flat blade screwdriver. Maybe you're replacing your parking light because you broke it on those small fender-bender or something or maybe you want to replace the parking lights and the headlights at the same time so you can take your truck from looking this and now with a new set of lights like this. Let's check that out again. Here is the before. Old lights. Now, here with new lights from 1A Auto. I had about 45 minutes to an hour with basic tools. It looks like you took about 100,000 miles off the front of your truck. If you're replacing your parking lights, think about replacing your headlights too.
Use a Phillips screwdriver work it into this screw get it to turn a little bit and then use a flat blade screwdriver and pry it up. The center should come up first and then it should come out. Once you have that out, pull on the light and you can shake it loose. If you pull really firmly, it comes forward. Then, around back here is your connector. You could press the button and disconnect the bulb, change the bulb, twist counterclockwise. Pull it out back in. You can see the new light from 1A Auto, nice and clear. New one's not in bad shape but definitely the new ones are a little bit more clear. When you're putting it back in, this tab here, the fender goes between this tab here so plug your bulb in and feed it in. Look back here and see how it's going in. Make sure it's pressed against the light. Make sure it's up on top there. Okay, clips right in. Put the little top clip. Push it together. Now you're all set.
We hope this helps you out. Brought to you by www.1AAuto.com , your source for quality replacement parts and the best service on the internet. Please feel free to call us toll free, 888-844-3393. We're the company that's here for you on the internet and in person. Thank you very much.
