Replaces
Replaces Chevrolet GMC Front Driver & Passenger Side 2 Piece Strut & Spring Assembly Set Truck-Plus Leveling Assembly KYSSP00534
$787.95
Replaces Chevrolet GMC Rear 4 Piece Suspension Kit General Motors OEM 1ASFK08556
$738.95
Replaces Chevrolet GMC Front & Rear 4 Piece Shock & Strut Kit KYB KYSSP00358
$734.95
Replaces Chevrolet GMC Cadillac Front Driver & Passenger Side 2 Piece Wheel Bearing & Hub Assembly Set ACDelco ACSHS00002
$684.95
Replaces Chevrolet GMC Cadillac Rear Driver & Passenger Side 2 Piece Axle Shaft Set Dorman OE Solutions 1AACS00045
$657.95
Replaces Chevrolet GMC Rear Driver & Passenger Side Leaf Spring 2 Piece Set General Motors OEM GMSFK00016
$625.95
Replaces Chevrolet GMC Cadillac Front 14 Piece Steering, Suspension, & Drivetrain Kit TRQ PSA58882
$579.95
Install Tip: You may be required to reset the vehicle computer after installation of this part.
Highest Quality MaterialsMade from highest quality materials that meet or exceed OEM standards
Quality Tested - built to a strict level of product standards.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years. We're dedicated to delivering quality auto parts, expert customer service, fast and free shipping, all backed by our 100% satisfaction guarantee. Visit us at 1AAuto.com, your trusted source for quality auto parts.
We're going to remove the mass air flow sensor. It's right here off the air box air cleaner assembly. Start by unplugging it. Place that aside. This is a T-15 Torx screw. Make sure you grab those screws so you don't drop them. Just pop this out. It's got a little seal on it. It'll come right out.
This is the old mass air flow sensor. It's got five pins in there. This is the new one. Five pins. Virtually identical. These are your heating elements and sensing elements in here. You don't want to touch those. Just leave them alone. It's got the O-ring in here that's going to seal on the intake tube. This should fit right in.
We're going to install our new one. It does have a key here and a key here. It also has an arrow in the direction of airflow. You just want to make sure that this arrow is pointing towards the engine, 'cause otherwise this key way shouldn't let you install it, but you don't want to try to force it. That should seat right in there on the O-ring. You'll feel it seat right in there. You got your screws, T-15 Torx, just have a very light Torx. Basically hand tight, 'cause they're just screws in the plastic. To complete it, just plug the harness back in.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
