Replaces
Part Details
TRQ ignition coils will have your engine running like new. TRQ ignition coils are manufactured to precise specifications using premium raw materials to optimize each vehicle's ignition system. To ensure peak performance, TRQ recommends replacing ignition coils in sets to prevent electrical output imbalances. All products are fit and road-tested in our Massachusetts R&D facility to ensure we deliver on our promise of Trusted Reliable Quality.
Product Features
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace an ignition coil in a 2004 Chrysler Sebring sedan. It's got the 2.7 liter V6 engine. For this repair you'll need a new ignition coil from 1A Auto as well as an 8mm socket and ratchet. Here's an engine cylinder diagram for the 2.7 liter V6, so if you have an engine code for a cylinder number two or cylinder number five misfire, that very well could be a bad coil. In this video we're going to be doing cylinder number two.
Go ahead and locate your ignition coil packs. That's two, four, and six. On the backside it's one, three, and five on the end right there. We're going to be doing ignition coil number two. We're going to first push down on the tab for the connector and pull that free, set it aside. Then take your 8mm socket and ratchet and start to unscrew the two screws that hold it in place. I'll fast foward as I do that. Now with those screws out you can go ahead and pull out your ignition coil.
We're replacing the coil with a new coil from 1A Auto. You can see it goes right in. Use the same screws to fasten it down. Put them in by hand first and tighten them up. After that just reconnect. All the other coils are the exact same and the rear ones are just a little bit tougher to get to. You may have to use a 10mm wrench rather than a socket and ratchet.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
