1997 Honda Accord Coupe L4 2.2L Front Ceramic Brake Pad & Rotor Kit with Wheel Bearings TRQ BKA14614

1. step 1 : Removing the Wheel 1:00

   • Remove center cap
   • While your car is still on the ground, use your 21mm socket to loosen your lug nuts
   • Jack up and secure your car with jack stands
   • Remove the lug nuts with your 21mm socket and ratchet
   • Remove the wheel and set aside

2. step 2 : Removing the Calipers 1:30

   • Remove the 14mm bolts to remove the calipers
   • Use a wire tie to fasten the caliper out of the way
   • Use your 17mm socket and ratchet to remove your caliper brackets
   • Pop out your brake pads

3. step 3 : Install New Pads 4:07

   • Check your caliper pins to make sure they are in good working order
   • Put your caliper bracket back on, and tighten the 17mm bolts to 70 ft lbs
   • Insert your new pads into the brackets
   • Use your C-clamp or caliper tool to compress your caliper
   • Place your caliper onto the bracket
   • Tighten your 14mm bolts

4. step 4 : Replacing the Wheel 7:25

   • Make sure to use a star pattern when putting your wheel lugs back on
   • Tighten to 75-85 ft lbs
   • Replace center cap

5. step 5 : Testing the Brakes 8:20

   • Before driving the car again, start it up and pump the brakes a few times to get the pistons in the brakes in place
   • Test the brakes in your driveway before taking the car onto the road

Tools needed

• 21mm Socket

  Large C-Clamp

  Flat Blade Screwdriver

  Torque Wrench

  14mm Socket

  17mm Socket

  Jack Stands

  Lug Wrench

  Ratchet

  Floor Jack