Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Open the hatch. Tail light is held to the body. Two 10 millimeter bolts and a clip that's out here. These also have a Phillips head opening in them. You can use a Phillips head screwdriver. But I'm going to use a 10 millimeter socket and ratchet. It's a little bit easier. They shouldn't be in there very tight, and they should come right out. Put this bolt aside so I don't lose it. I want to move to this side.
Basically there's a clip right here, so it needs to push straight out. There's a couple pins holding it in. I'm going to push from the back. It does sound like it's breaking, but it takes a good amount of force to get it free. I was sliding it off of this pin that slots into here in the tail lamp, and then it also needs to come off the two little pins here that are located here. Once it's out, there's a main connector.
Now push in the lock. Pull it out. The whole tail light assembly can be removed now. To reinstall it plug it into the main harness.
To reinstall it, we're going to want to line it up and slide it over that pin. And it's also going to slide over these locating pins here. So get it just lined up like that, push it over, and push it straight in. It'll snap when it's in place. Reinstall the bolts. Do the same for the other one. This procedure will be the same for both sides.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
