Replaces
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to service the tail light on this '96 Ranger, same as a '93 to '97. We're going to show you both replacing the whole assembly, and just changing the bulbs as well, and the only tool you'll need is a Phillips screwdriver.
To replace one of these tail lights on a Ranger, there are four screws. You can see there are two Phillips screws out here, and then also two Phillips screws right in here. I'll speed up as we just remove those two screws from the outboard side of the tail light. Sometimes these inside screws can be a little sticky so you want to make sure you can get some good leverage on the screw driver. Once those are out, the light comes right out.
If you're just looking to change bulbs, all these just turn counterclockwise. The bulb comes straight out of the socket, and back in.
Here's the original and a new one from 1A Auto. Obviously, my original is in pretty good shape, but maybe you backed into something and broke a tail light, or something like that. The new one from 1A Auto is going to go in, just the same as the original one. Push them in. Lock them in clockwise. It's better to do the bottom one first, push it in, and lock it in. Take the middle one. I'm just going to make sure we get all the right ones here lined up correctly. Push it in, lock it in clockwise, put the light into place, and start my two inside ones, first. Now, on these outer ones, you can see right here is the clip where it goes into, so you can put your screw in, and make sure the screw goes into that clip. Start the top one a little bit, and make sure that bottom one goes in. Speed it up here. You want to be careful not to tighten these screws up too much because you could crack your tail light lens.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
