Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
In this video we're going to show you taillight replacement, both replacing the bulbs or the entire assembly itself if you broken it backing into something or something like that. The only tools you need are a Phillips screwdriver and a 10mm wrench or socket and ratchet.
Taillights, you know, you wiped out backing into something or whatnot. Okay, on this car, somebody had this apart be before. What you encounter is this little plug, you just pry that out with a screwdriver. Then down low, there's a little Phillips kind of screw plug. Once you take those out, you can just kind of pull that right out. If you're just looking to change the bulbs, you can get your hands in here usually, you want to turn them counterclockwise and pull out, and the bulbs pull right out of the socket. Push right back in. Okay, now there's three 10mm bolts. One, two, and then the 3rd one, right over here. Okay, you can use a 10mm or even an adjustable wrench. Just loosen up the nuts, they came right off.
Once those are off, you kind of break the seal, usually stuck pretty well. Pull it out. Okay, there's a connector right here, push down on the little tab. Disconnect the connector. Okay, a new light from 1A Auto, plugs right in. You start the outside one first and push it in. There's a gasket on it so you'll have to just slowly tight it up. From here, just put those three 10mm nuts back on. Tighten them up with your wrench or socket and ratchet. You want to make them firm but don't over tighten them. Okay, now take your panel, you need to put it underneath. Lift up your carpet, slide the panel underneath, put it back in place, and put your fasteners back on.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the internet and in person.
