Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
In this video we're going to show you how to replace a taillight on this 2002 Toyota Tacoma. You might want to replace it if you've backed into something or something like that. The only tools you'll need are a Phillips screwdriver and a flat-blade screwdriver.
There's four Phillips screws recessed into the light. I'm just going to speed it up as I remove those four screws. Once you remove the screws, behind here, there's a little tab right here, press it down and disconnect. Use a flat-blade screwdriver. There's little clips in here. Push down on the top of the clip and push it out, and up on the bottom of the clip. Push it out. There's another one right here.
New light from 1A Auto comes with those clips already installed, so plug it in here. Guide both of those clips right in. So you've got the clips on the inside part. Now you just guide those screws for the outside in where they're suppose to go. Tighten them up and you've got a nice taillight installed.
We hope this helps you out, brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free 888-844-3393. We're the company that's here for you on the internet and in person.
