Replaces
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to service your taillight. This is a 2003 Honda Pilot. This is the same for any 2003 to 2008 Pilot. You only need new taillights from 1AAuto.com. We sell good replacements if you've broken one of your rear taillights. You also need an 8mm socket and ratchet or a Phillips screwdriver.
Start out by opening the tailgate, and there are either two 8mm or Phillips screws. We'll remove those. Once those are out, there are two pins to hold it to the body, so pull it out and then pull back at the top and then back at the bottom to pull those pins out. To change bulbs, just turn the sockets counterclockwise to pull them out and then the bulbs come right out just by pulling.
To change the whole taillight assembly, pull the wires from the little clips in the taillight.
Here's the new taillight from 1A Auto. Remove the covers, these little shipping covers, and then just put the harnesses back in place. As you're putting the harnesses back in place, clip the wires back into the clips that are in the taillight. You just have to look at each one, kind of line it up correctly, put it in, and twist it clockwise to lock it in place.
Then you want to line up the two pins with the holes in the body. Once you get them lined up, push it in to lock those pins. Then replace your two screws. Obviously it's the same for both the passenger side and driver's side.
Thanks for tuning in. We hope this video helped you out. Next time you need parts for your car, please visit 1AAuto.com. Also check out our other helpful how-to and diagnosis videos.
