Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks. In this video, we show you how to service the taillight on this 2005 Dodge Durango. The only tool you'll need is a T25 Torx driver. We show you both if you just need to change bulbs as well as if you need a whole new taillight because it's broken. We do sell the new taillight assemblies at 1AAuto.com.
Okay, to service your taillight, obviously open up the tailgate. These little clips here, use a screwdriver and then start prying them out. Then pull them right out. Then grab hold of your taillight and pull it down and out. Then here is a little kind of safety tab. Use the screwdriver again. Pry this down, and then squeeze and disconnect there.
Okay, if you break a taillight, you'll want to replace it with a new one from 1A Auto. You'll want to take all these kind of shipping covers off. Then, again, remove your connector plate for the newer one. I'm just going to speed up here. I'm using a T25 Torx screwdriver to remove the three screws that hold the connector plate into the taillight. If necessary, the bulbs pull straight out and then push in. Okay. The connector plate goes right into the new 1A Auto light. You'll just have to kind of use a little force to start the screws in.
Here, again, I'm just going to fast forward as I install those three screws. When you tighten them up, you want to tighten them up firm, but don't over tighten them. Okay, make sure you reconnect and lock that on. There's a couple just some little pins here that go right into receptacles there. Kind of look them in. Put that right on and push these pins into place.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free 888-844-3393. We're the company that serves you on the internet and in person.
