Replaces
Replaces Chevrolet GMC Buick Saturn Front 16 Piece Steering, Suspension, & Drivetrain Kit TRQ PSA66560
$566.95
Replaces Chevrolet GMC Buick Saturn Front 14 Piece Steering & Suspension Kit TRQ PSA66554
$425.95
Replaces Chevrolet GMC Buick Saturn Front 10 Piece Steering & Suspension Kit TRQ PSA69982
$404.95
Replaces Timing Chain Set Preferred Components Inc TS11004
$389.95
Replaces Chevrolet GMC Buick Saturn Front Driver & Passenger Side 2 Piece Strut & Spring Assembly Set Monroe Quick-Strut MNSSP01077
$374.95
Replaces Chevrolet GMC Buick Saturn Front & Rear 6 Piece Complete Strut Assembly & Shock Absorber Kit TRQ SKA64309
$370.95
Replaces 8 Piece Ignition Kit DIY Solutions ENG00683
$364.95
Replaces Chevrolet GMC Buick Saturn Driver & Passenger Side 2 Piece Wheel Bearing & Hub Assembly Set Timken TKSHS00724
$358.95
Replaces Chevrolet GMC Buick Saturn Rear 12 Piece Suspension Kit TRQ PSA69630
$355.95
Part Details
Product Features
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Open the tailgate. Use a small flap of the screwdriver, and remove these two caps to get to the screws underneath. Just pop them out. Got a little tether to keep them in there. The same for both. These are seven millimeter head screws. I'm just using a socket and a driver handle. Remove these. Now, we need to push the tail light straight off of the quarter panel. There's a clip behind here. Just going to give it some force and going to push it. It came out pretty easily. There's a pin here that it's stuck on. Just push it out.
To replace the whole assembly, you can unplug it. Push in the lock, pull the connector off. Reconnect the harness. It'll click when it's locked in place, reinstall the assembly. I'll line up this pin, it's going to go right into that grommet there. That's it. Reinstall the self-tapping screws. Just tighten it in, and it'll get tight, just stop. Push these back into place. It'll snap right into place. The opposite side is the same exact procedure.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
