Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1AAuto. We've been selling auto parts for over 30 years.
To get to your fog light bulbs, this will be the same on both sides. Go up here. There is a white clip that's locking the connector to the bulb. It's actually kind of gray. Lift it up, and then push the connector back to unlock it.
With the light unplugged, we can remove the three bolts holding the fog light in place. They're 10 mm, I'm gonna use a 10 mm socket extension and ratchet. Start with this top one here. Do the same for the other two.
The fog light assembly is going to start to get really loose. Gonna hold it with one hand, so it doesn't fall out. Get this bolt out of here.
With those bolts removed, we can pull the fog light right out of here. The harness is clipped to it, so we'll pull it off like that and just slide it right out.
Here's our original fog lamp, driving lamp assembly from our vehicle, and our brand new replacement one from 1A Auto. Comes with a bulb. This is how you would adjust the aim. The bracket is the same, has this protective plastic on here, we can peel this off. This is the passenger side, but the driver's side is identical, and the procedure to replace it is very similar, just the opposite side. This is gonna work great, fit great and look great in your vehicle.
We're gonna reinstall this. Here's a little locating pin above this bolt hole here, and there's a corresponding opening in the bracket that's inside the bumper.
We're ready to put this in, we'll go up inside and this edge is gonna slide in just like that. And then the tab is gonna locate it right there. I'm gonna grab one of the bolts, I'll start with one of these top ones on the inside, 'cause it's started by hand.
And I'll do the same for the other two. Don't want to crack the plastic. Once you feel it get tight, you can stop. And the final one. And the harness up in place here. It'll slip back in and then, of course, plug it back in to the light so it works. It won't really snap, but make sure it locks in place.
You need to adjust it, and you can turn this up or down to adjust the aim. The job is complete, the other side will be very similar.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
