Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the headlight bulbs as well as the parking light bulbs on this 2010 Buick Enclave. We show you on the passenger side, but the driver side is the same procedure. The only tool that you're going to need for this is a Phillips screwdriver or a Phillips bit and drill.
Inside your wheel well, there are five Phillips screws, and you can use a pick to just clean out the dirt that gets jammed inside of them. Then, using a Phillips screwdriver or a Phillips bit and a drill, just remove those five Phillips screws. Pull back the panel and from in here you have full access to the back of your parking light and, up here, to the back of your headlight.
Change the smaller bulbs in the headlight. You just twist them counterclockwise and pull the socket down. The bulb pulls out. You push your new bulb in and twist the socket back in to lock it in.
Next, we'll show you the driving light. Out on the white tab, and then push down and off and then twist the bulb out counterclockwise. This other bulb also just twists out. Pull it down. The old bulb pulls out. The new bulb pushes in. Then just twist the socket back in, clockwise to lock it. For this bulb, take your new one. Twist it into place clockwise. Then, reconnect the harness.
Put the panel back into place and replace those five Phillips screws.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
