Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
How to Replace Tail Light 1997-2003 Chevy Malibu
Created on:
Tools used
No Tools Needed
1. Removing the Taillight
Twist off the top clip in the trunk.
Pull down the insulation.
Twist off the three wing nuts.
Pull the taillight out and off.
2. Replacing a Bulb
Disconnect the harness.
Pull back the tabs and pop out the connector plate.
To replace a bulb pull the bulbs out and push a new one in.
Push the connector plate into place.
3. Replacing the Taillight
Connect the harness.
Line up the taillight and press it into place.
Replace the three wing nuts.
Replace the insulation.
Twist the top clip back into place.
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
In this video, we're going to show you tail light replacement on this 2001 Chevy Impala, same as a '97 to '03, and no tools are necessary.
To replace the tail light, pretty easy, you're going to see a loosen type of. Then, you pull this back, and then there's three wing nuts, and you can also use, I believe, a 10-mm wrench. Remove those three.
Tail light pulls back. If you're looking to replace a bulb, you want to disconnect your connection here, which basically from the bottom, there's a little tab and pull. Here's a little tab, and you pull that connector. There's your tail light off. Your bulbs are back in here. Pull up on these little tabs. You can see there's water in this one. Pull that plate off. Then, the bulbs just pull right out. Then once you have this plate off, the bulbs pull out and push back in. The plate just pops right back on like that.
New tail light from 1A Auto. Everything is going to go in just the same. Pops right in. Just kind of make sure you use the plug in the right spot. Pop that on. Then, make sure all your studs go in and then use your nuts on the back side. Then, you just put this back in place and you're all set.
We hope this helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll free 888-844-3393. We're the company that's here for you on the Internet and in person.
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Chevrolet is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Chevrolet or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.