Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
Created on:
Tools used
This video is brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Today we're going to replace a parking light for a GM truck and SUV. All that you need is a Phillips screwdriver. It's a pretty easy process.
There are four Phillips screws that hold the parking light on here. Use a Phillips screwdriver. In this case, we have a screw gun and we'll speed the video up a little bit for you. Once those screws are out, the parking light comes right out. There's little thumb locks and you just twist the bulbs and pull them out. Your parking light is out.
Replacement is just a reversal of the procedure. You take your light, put the bulbs in, twist and lock them into place. Put the light in its place. You have your four screws. In a minute we'll speed it up again for you. Thread the four screws in first and then use your power tool or just a regular screw driver and tighten the screws. The screws don't have to be over tight. It is a plastic lens so you don't want to tighten it too much and break the screws. That's it.
Remember this video is brought to you by www.1AAuto.com. The parts in this video can be resourced there. We thank you and we hope this helps with your project.
