Replaces
Replaces Chevrolet GMC Hummer 8 Piece Fuel Injector Set Standard Motor Products 1AEEK00488
$429.95
Replaces Chevrolet GMC Front 12 Piece Steering & Suspension Kit TRQ PSA30336
$424.95
Replaces Chevrolet GMC Driver & Passenger Side 2 Piece Headlight Set General Motors OEM GMLHP00001
$409.95
Replaces 1992-98 Chevrolet Suburban C2500 without Heat Vents Complete Carpet Auto Custom Carpets 20936-160-1077000000
$387.95
Replaces 1992-98 Chevrolet Suburban C2500 without Heat Vents Complete Carpet Auto Custom Carpets 20936-160-1085000000
$387.95
Replaces 1992-99 Chevrolet Suburban C2500 with Heat Vents Complete Carpet Auto Custom Carpets 20508-160-1077000000
$387.95
Replaces 1992-99 Chevrolet Suburban C2500 with Heat Vents Complete Carpet Auto Custom Carpets 20508-160-1085000000
$387.95
Replaces Chevrolet GMC Front 10 Piece Steering & Suspension Kit TRQ PSA30335
$381.95
Replaces Chevrolet GMC Front Ceramic Brake Pad & Rotor Kit with Calipers TRQ BKA18478
$349.95
Replaces Chevrolet GMC Front 6 Piece Suspension Kit TRQ PSA30326
$344.95
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
This video is brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Today we're going to replace a parking light for a GM truck and SUV. All that you need is a Phillips screwdriver. It's a pretty easy process.
There are four Phillips screws that hold the parking light on here. Use a Phillips screwdriver. In this case, we have a screw gun and we'll speed the video up a little bit for you. Once those screws are out, the parking light comes right out. There's little thumb locks and you just twist the bulbs and pull them out. Your parking light is out.
Replacement is just a reversal of the procedure. You take your light, put the bulbs in, twist and lock them into place. Put the light in its place. You have your four screws. In a minute we'll speed it up again for you. Thread the four screws in first and then use your power tool or just a regular screw driver and tighten the screws. The screws don't have to be over tight. It is a plastic lens so you don't want to tighten it too much and break the screws. That's it.
Remember this video is brought to you by www.1AAuto.com. The parts in this video can be resourced there. We thank you and we hope this helps with your project.
