Replaces
This window sweep set(window felt) is the highest quality available. This is the strip set that attaches to the tops of the doors and "sweep" the windows as they go up and down. Also known as glass sealing strips.
Features:
If your window sweep set is cracked and allowing the elements into your door, this is for you
Item Condition:
New
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the window sweep on this 1996 Chevy Tahoe. We show you on the driver side but the passenger side has the same procedure. The items you'll need for this include a new window sweep set from 1AAuto.com, a 7mm and 10mm socket and ratchet, wire cutters, a flat blade screwdriver, a punch or drill, pliers, and some heavy duty staples.
Start off by removing this triangular panel. You just pull it. Next, you want to remove these two 7mm bolts. We'll just fast forward as Don does this. Next, pry up your switch panel and then just slide it back. Now, using your flat blade screwdriver, push the tabs on these harnesses and pull them free. For the speaker harness, you just push on the tab right here and pull it free. Now, using the flat blade screwdriver, pry out this bezel and it just pulls off. Now, you want to start prying out along the edges of the door panel. Try to feel for where the clips are and pull them free.
Now, you can lift it up and out of the window sill, and you just want to twist out your courtesy light socket. Remove this foam insert and then pull up this wire and using a flat blade screwdriver. Pull back the tab and disconnect this harness. Then, you want to remove these three 10mm nuts. We'll just fast forward as Don does this. Now, pull your mirror off. If you have one of these rain guards, you will have to peel it from the mirror first. Now, to remove this window sweep, you want to push back and pull up, and that will release it.
Now, for the window sweep attached to the door panel, you're going to have to remove a series of staples. Using some wire cutters, just try to get them underneath and pry the staples up and out. You want to repeat that process on all of them and then it pulls free. Take your new window sweep and line up the holes. You just want to punch a hole through the new window sweep down into the old holes. If the stapler you're using is a much different size than the one you used previously, you may have to make a new hole for the other side, push the staple through the window sweep, and then use pliers to help you push it through the door panel. Make sure you just bend those tabs underneath. Then, just repeat the process all the way down the window sweep.
Take your new window sweep that goes onto the door and just push it down into place. Making sure that it's re-clipping. Then once it's re-clipped, feed your harness back through the door and put your mirror back into place and replace those three 10mm nuts. Reconnect your mirror harness and push that foam back into the door.
