Replaces
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video we're going to show you how to replace your blower motor resistor on this 2005 Ford Focus. It's the same part and process on these vehicles from 2000 to 2007. The items you'll need for this are a new blower motor resistor from 1AAuto.com and an 8mm socket and ratchet.
Open your glove box, and on other side there are tabs. Just push in the sides of the glove box and pull it down. Your blower motor resistor's located right here. There's a harness connected to it. Push the tab on the bottom of the harness and pull the harness free. Next, you want to remove the 8mm bolt at the bottom of the resistor. We'll just fast forward as Don removes that. Once the bolt's removed your resistor just pulls out.
On the left, is the old one. On the right, is the new one from 1A Auto. You can see they're identical and they're going to mount exactly the same. Push your new resistor into place and then twist in, by hand, that 8mm bolt. Then tighten it up with your socket and ratchet. Next, reconnect your harness. Then, push in the sides of your glove box and close it, and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
