Replaces
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Acrylonitrile and Butyl benzyl phthalate (BBP)d, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1A Auto. We've been selling auto parts for over 30 years.
Hi, everyone. Sue here, from 1A Auto, and today, on our '06 Honda Element, I'm going to be installing a rubber brake pad. It's the same interchangeable for the clutch pad also. This came from 1A Auto. If you need this part, or any other part for your car, click on the link below and head on over to 1aauto.com.
The brake pedal pad is here, and this is the clutch pad. These are interchangeable pads. I'm going to replace the brake pad because it's worn at an angle. You reach in the back here, and you feel a rubber lip, and you just start peeling that up. There you have it. There's the rubber lip.
Here, we have the new brake pedal pad from 1A Auto. This was the factory one. They're interchangeable. They're both the same for the clutch or the brake pad. You can see they have the same installation divot in the lip that wraps around the middle pad. If you need this part or any other part for your car, click on the link below and head on over to 1aauto.com.
I like to install the bottom part of it first, because it has this little cut out that you can feel on the back, and bring a small screwdriver, if you need to, around. I install the bottom part—grip the corner. You basically just pull out on the edges, and then you get the top part last. I like to just put my hand in there—just mold it. Make sure the lip goes all the way around, and you're all set.
Thanks for watching. Visit us at 1aauto.com for quality auto parts, fast and free shipping and the best customer service in the industry.
