Replaces
Part Details
This Ignition Kit comes with NGK Laser Iridium Spark Plugs and TRQ Ignition coils.
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
To open the hood, go inside. The latch is way down here by your left foot. Hood release for the safety is under here. Lift it up. The hood has two positions. There's one here. It also has a service position down here. Push the hood away a little bit, this way you don't bump your head into the hood. Now, remove this plastic cover.
There's four 10 millimeter nuts on top. Use a socket extension and ratchet to remove them. It'll show that they're actually a bolt, with what looks like a nut on top. They have a little shoulder on them. Then put these bolts aside so I don't lose them. With the plastic cover off the engine, underneath it are your coils. All four coils can be removed in the same way. Push down on the connector lock. Pull the connector off.
There's a ten millimeter bolt holding the coil to the top of the valve cover. Break that free and put that aside. Pull the patch and lift straight up off this spark plug on the valve cover and out of the head.
Install your new coil pack. Push it right down onto the opening and onto the spark plug. It'll slide right into place.
Reinstall the bolt. Torque is 7.8 foot-pounds. It’s very light. I'm just going to do it by hand. Once I feel a good tight, I will stop. Just like that. Plug the connector back in. It'll click when it's locked into place, and then I'll just repeat this for the other three.
Reinstall the plastic cover, put these shoulder bolts back in. Just tighten them up, not too much, they're only holding onto the plastic and you don't want to crack the aluminum valve cover. So once you feel them get tight, just stop. Put the car prod back in its spot, and you're all set.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
Tools used
Tools used
Tools used
