Replaces
Returns: Parts with electrical components cannot be returned once installed.
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
How to Replace Blower Motor Resistor 1992-98 Honda Civic
Created on: 2013-12-20
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the blower motor resistor on this 1998 Honda Civic. It's the same for any 1992 to 2000 Civic. Basically, you'll know when your resistor is going when you lose fan speeds. For example, your fan works on speed one and speed four, but not two or three; that's basically the symptom of a bad resistor. The items you'll need for this include a new blower motor resistor from 1AAuto.com and a short Phillips screwdriver.
Open up the glove box, push in both sides, and just pull it down. Behind here is your blower motor resistor. Push in on the tab on the harness and pull it up and off. Then remove these two Phillips screws. We'll just fast-forward as Don does this. The resistor lifts right up and out.
On the right is the old blower motor resistor; on the left is the new one from 1A Auto. You can see they're identical, and they'll mount exactly the same. Put your new blower motor resistor down into place, and replace those two Phillips screws. It's easier to just twist them in by hand until they're lower so you can fit the screwdriver in there and then just tighten them up. Now, reconnect your harness, push in the sides on your glove box, and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
HCA40084
