Replaces
Part Details
Product Features
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace an ignition coil on this 2006 Jeep Liberty with the 3.7L V-6 engine. The only items you'll need for this are a new ignition coil from 1AAuto.com and a 10mm socket and ratchet with an extension.
Right here, is ignition coil 1, 3, and 5. On the other side, is ignition coil 6, 4, and 2. We're going to show you how to replace ignition coil 1, but it's a similar procedure. You just pull that hose out of the bracket, disconnect the harness by pushing the tab and then remove that hose clamp. This just pulls right off of the stud. Then, you want to remove this 10mm nut. We'll fast forward as Don does this. Once that's removed the ignition coil pulls right up and out.
On the left, is the old ignition coil. On the right, is a new one from 1A Auto. You can see they're identical. They're going to mount exactly the same. Take your new ignition coil and push it down into place. Now replace that 10mm nut and tighten it up. We'll fast forward as Don does this. Reconnect your harness. Push that hose clamp back into place. Re-clip the hose into place. Then you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
