Replaces
Replaces 2002-04 Jeep Liberty Front 14 Piece Steering & Suspension Kit TRQ PSA32052
$384.95
Replaces 2002-04 Jeep Liberty Front 12 Piece Steering & Suspension Kit TRQ PSA59075
$359.95
Replaces Jeep Dodge Alternator ACDelco 335-1287
$357.95
Replaces 2002-04 Jeep Liberty Front 8 Piece Suspension Kit TRQ PSA32056
$332.95
Replaces 2002-04 Jeep Liberty Front 6 Piece Control Arm with Ball Joint Set TRQ PSA56376
$309.95
Replaces Jeep Liberty Wrangler Rear Driver & Passenger Side Brake Rotor Backing Plate 2 Piece Set Dorman OE Solutions 924-657
$305.95
Genuine original equipment part (OEM) that was factory installed on your vehicle by the manufacturer.
Item Condition:
New
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
1 Year Warranty
This item is backed by our 1-year warranty. In the event this item should fail during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com your source for quality replacement parts and the best service on the internet. Hi. I'm Don from 1A Auto. I hope this how-to video helps you out and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks. In this video, we're going to show you how to replace the throttle position sensor on this 2006 Jeep Liberty with the 3.7 liter V-6 engine. The only tool you'll need is a T20 Torx bit and a ratchet.
Your throttle position sensor is located right here. You want to start off by pulling out this red clip on the harness, pushing the tab and pulling the harness free. On your throttle position sensor, there are two T20 Torx bolts. There's one there and one right there. Just go ahead and remove those. We'll fast-forward as Don does this. Once those are removed, the throttle position sensor will pull right off. Then take your new one, push it into place and replace those two T20 Torx bolts. Again, we'll fast-forward as Don just tightens those up. Reconnect your harness. Push in the red clip and you're all set.
We hope this video helps you out brought to you by 1AAuto.com your source for quality replacement parts and the best service on the internet. Please feel free to call us toll-free 888-844-3393. We're a company that's here for you on the internet and in person.
