Fit and worked
Replaces
Fit and worked
It fit like a glove and looked exactly like the old one!
Good!
Fast shipping and good pricing
It broke after being installed for 3 months
The drive shaft is already bad.
Drive shaft virbrates at highway speed's, 45mph +, vibration can be felt and heard. Not sure if its because the shaft has no balancing weights or what but I will be returning.
I installed the driveshaft myself on my 2000 Jeep Grand Cherokee 4x4 4.7L V8 and thought it needed balancing but it was actually grease in the boot causing it to vibrate at speeds >65mph. I found this out the hard way because on the day of installation, the boot ripped while driving on the highway leaving a quarter-sized whole in the side of the boot. This threw grease all over my undercarriage but I was stratified in knowing that I not longer had a vibration until higher speeds (that I would not go anyway). However, recently (now about 2 months and <1,500 miles after installation) I was driving on the highway and the entire boot ripped apart and knocked an ABS sensor connector apart (no big deal since the connector just snapped back together but it was pretty scary for all of that to happen at 60-65mph). There could be underlying issues on my vehicle that would aid in the destruction of the boot but I can't think of anything that would cause that to happen. I will just be purch
went online ordered my part boom it was here within a few days i'll order from 1a auto again no questions.
Bought this front shaft that replaced the original. It fit perfect and works great. Yes, this is worth recommending
It comes withe new hardware.
No grease is needed. Each joint is prepacked with grease.
Thank you for your inquiry. Actual Measurements are not listed or available. Our parts are exact replacements for your vehicle's OEM parts. As long as your year, make, and model match up with our listing, these parts will directly fit and function like the originals. Please let us know if you have any other questions. Thank you!.
The measurement from weld to weld is 20 inches.
Thank you for your inquiry! The fit of this specific product is not dependent on if the vehicle is or is not equipped with the Quadra Drive system. In order to confirm the fit of these parts you would need to know the engine size, the length of the OE shaft from weld to weld, as well as if the OE shaft was a CV joint style or U-Joint style. This particular product is specific to models with a V8 4.7L engine, has a 20 Inch measurement (weld to weld) and is also the CV Joint Style Design. Please let us know if you have any further questions, thank you.
We have the 4.7 V8 it was to long and could not switch the end cuz ours has the fine splins
Yes
Thanks for your question! These items have a lifetime warranty on them for vehicle with a factory suspension. Thanks!
Yes, noise and vibration
Bolts are not included. You may reuse the existing bolts or purchase from a separate vendor.