Replaces
4 Piece Control Arm Set
$127.95
6 Piece Suspension Kit
$144.95
8 Piece Suspension Kit
$147.95
10 Piece Suspension Kit
$169.95
8 Piece Control Arm Set
$219.95
14 Piece Steering & Suspension Kit
$264.95
12 Piece Steering & Suspension Kit
$274.95
18 Piece Steering & Suspension Kit
$373.95
16 Piece Steering & Suspension Kit
$375.95
20 Piece Steering & Suspension Kit
$405.95
Part Details
Our control arms are designed to be direct replacements for the original factory parts. They are 100% brand new and require no modifications for installation. No special tools are required because all of the bushings come pre-installed.
Our steering and suspension components are pre-greased and sealed for long life and do not require the extra maintenance typically required by greaseable versions.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
with the vehicle raised and supported on
jack stands you can now go ahead and
support the axle
with your jack
just to take the
pressure off of that you don't want to
lift the suspension
using a 10 millimeter socket go ahead
and remove the screw
go ahead and remove this 10 millimeter
and just slide the heat shield to the
side
using 18 millimeter wrench
and 18 millimeter socket
i'm gonna go ahead and remove this upper
bolt here
using an 18 millimeter
shallow socket ratchet we're going to go
ahead and loosen this bolt
and so you want to go ahead and hold
that in place
go ahead and remove this
and then you can remove
the nut with the tab
next we'll remove the bolt
pull it out of the way and remove the
upper control arm
reinstallation we're just going to
reverse
take the bolt
you want to line this up
feed the bolt through
just far enough so you can get that
nut started
you can get that started in there you
might want to give it a
want there to get that in
the screwdriver on the other side
just to help wind things up a little bit
as you tap that in
go ahead and get that nut started on
there
just going to go ahead and
snug this bolt down
we're going to snug down the
other control arm bolt
on the axle side
and then we're gonna
go ahead and torque these bolts down
go ahead and torque the upper
bolt to 75 foot-pounds
and go ahead and torque the rear
bolt to 75 foot pounds
go ahead and reinstall the heat shield
that 10 millimeter
go ahead and snug that down
i'm going to go ahead and lower the
support jack from the axle
and remove this
