Install Tip: You may be required to reset the vehicle computer after installation of this part.
Quality Tested - built to a strict level of product standards.
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
How to Replace Air Flow Meter Sensor 2005-10 Pontiac G6 2-4L 4 Cyl
Created on:
Tools used
T20 Driver
1. Removing the Mass Air Flow (MAF) Sensor
Remove the MAF sensor wiring harness
Remove the T20 Torx screws from the MAP sensor
Remove the MAF sensor
2. Installing the MAF Sensor
Insert the MAF sensor in place
Tighten the T20 Torx screws to the MAP sensor
Connect the MAF sensor wiring harness
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the mass air flow sensor on a 4-cylinder Pontiac G6. This is the model year 2007. It's fundamentally the same from 2005 to 2010. You'll need a Torx 20 bit and a socket driver.
To remove the connector, pull the white tab back, and then press on the center and pull it out. There are two Torx 20 screws that hold the mass flow air sensor into the housing. You'll need a Torx 20 bit and the socket driver to remove those. Once you've got those screws out, go ahead and pull your mass air flow sensor out.
Install the mass air flow sensor. Then reinstall the Torx 20 screws that hold it in place. I go ahead and fast-forward as I tighten up those two screws. Reinstall the connector for the mass air flow sensor by pressing it on and then pushing in on the white tab.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
ESA48447
In Stock
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Buick is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Buick or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.