Replaces
Part Details
Product Features
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii and Alaska.
Shipping is not available to a P.O. Box, APO/FPO/DPO addresses, US Territories, or Canada for this item.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii.
Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Go inside the rear hatch and open up this little door here. It's the same for both sides. There's two little latches. Push them at the same time. Remove the tail lamp assembly, unplug the audio connector, and pull the harness out of the socket. Take a 10mm deep socket and ratchet. There's a single 10mm nut on the stud here. Loosen this up.
Since it's loose, I'm going to use just the socket and thread it off, being careful not to drop the nut. There it is there. There's two metal tabs right here above this socket. Pull them down and then push out. The tail light will come right out of the body. Don't pull it though because there's still wiring attached to the bottom. There's a marker light here. Use a small flathead screwdriver to pry open the lock and pull the gray connector out.
Remove the whole tail light assembly. To reinstall the tail light, plug back in the marker light. Click the lock into place, push the lamp into the body. There is a tab here that's going to match up with this grommet here. The clips that are in there kind of hold it. Take the nut, put it inside the socket, and carefully put it over the stud. Get it started and tighten it in. I feel a good tight, I'll stop. Plug the connector back in, lock in place, and put the door back on. The job is complete.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
