Replaces
Part Details
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
Remove the fog light bulb. To remove the fog light housing and get to the bulb, use our plastic prying tool. You can get these from 1aauto.com. There's a tab on the top and bottom. You'll start with the top one, pry it down, and then pop it right out. It's only going to come so far because the harness.
So there's a brown connector in there that's holding the harness in to the steel support in the back. And what you're going to have to do is reach in there and squeeze the two tabs and push the connector, push the clip out and then you'll get a lot more wire to come out with you. Reach my hand in here. It's a tight fit, squeeze it by and then with my fingertips I'm going to push the tabs in and push that clip out. I'm going to have to push in on the housing to give the harness just a little bit of give. And then really push that thing through. But you don't want to rip your harness trying to get the bulb out.
Once you get it squeezed together and started, you can reach a long screwdriver in there and kind of push it out. Now, once you have the headlight to the fog light assembly out and separated, you still can't get the bulb out because that stop is the way. So you have to unplug it from the harness, push it in the lock, just going to push in the lock, pull it off.
The fog light is held into the plastic bezel with one Phillips head screw. You take the Phillips head screwdriver, take it out. Slide it out a there and there's the lens assembly. To reinstall it in the bezel. These two tabs line up in these two notches over here. And it slides down. Put the single screw back in here. Tighten it down. Don't go too tight or we'll crack the plastic. It's ready to be reinstalled in the truck.
You plug the light into the harness. Click the locks in place. I'm going to reach in here and plug that back into where it belongs. Push this into place. It's reinstalled.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
