Replaces
Replaces Toyota T100 Tundra Rear Driver & Passenger Side Axle Shaft & Bearing Kit Dorman OE Solutions DMACS00003
$669.95
Replaces Toyota Lexus 8 Piece Ignition Coil Set Delphi DEERK00037
$531.95
Replaces Toyota Sequoia Tundra Front Driver & Passenger Side 3 Piece Steering Kit TRQ PSA58575
$470.95
Replaces Toyota Sequoia Tundra 2 Piece Exhaust Manifold & Gasket Kit Dorman OE Solutions 1AEEK00125
$458.22
Replaces Toyota Sequoia Tundra Front Ceramic Premium G-Coated Performance Brake Pad & Rotor Kit with Calipers DIY Solutions BFS02020
$443.95
Replaces Toyota Sequoia Tundra Power Rack & Pinion Assembly TRQ PSA67690
$417.95
Replaces Toyota Sequoia Tundra Front Ceramic Premium G-Coated Brake Pad & Rotor Kit with Calipers DIY Solutions BFS05432
$404.95
Replaces Toyota Sequoia Tundra Front Ceramic Premium G-Coated Brake Pad & Rotor Kit with Calipers DIY Solutions BFS05431
$396.95
Replaces 2000-02 Toyota Tundra Front 14 Piece Steering & Suspension Kit TRQ PSA30941
$387.95
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet. In this video we're going to show you how to replace the taillight, either replace the taillight bulb or the procedure for replacing the entire taillight. The only tool you'll need is a 10-millimeter wrench or a socket wrench with ratchet and maybe a pair of pliers and a flat-blade screwdriver.
Starting with your tailgate, open there are two 10-millimeter bolts on each side for each light. You want to remove those 10-millimeter bolts. We'll just kind of speed through removing those. You can use a 10-millimeter wrench or a socket and ratchet like I have.
Once you have those bolts out, pull it firmly. If you're looking to just change your bulbs, turn them counterclockwise. The socket comes out. The bulbs just pull out of the sockets. Your harness goes down into there. Up underneath you want to unplug your connector. There's a tab right here. You press and unplug. Then the connector is held onto the frame. You have to pull it off. Then this clip here that holds the harness on, you pull that off as well. You can get that from 1AAuto. It comes with everything including a harness and plug.
You see my old light is perfectly fine. I'm not going to go through all that changing out of the harnesses and stuff. To re-install I'll move it into place and make sure these tabs go into here and then down there as well. We'll fast forward again as I thread those bolts in by hand first. I might have to push on the light a little bit to get the holes to line up. Tighten them up with the socket by hand. Then tighten them up firm with the ratchet.
We hope this helps you out, brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the internet. Please feel free to call us toll free. 888-844-3393. We're the company that's here for you on the internet and in person.
