Replaces
Replaces VW Passat Front Driver & Passenger Side 2 Piece CV Axle Assembly Set GKN GKNK00169
$432.95
Replaces VW Passat Audi A4 Front Driver & Passenger Side 2 Piece CV Axle Assembly Set GKN GKNK00170
$378.95
Replaces VW Audi Front 14 Piece Steering & Suspension Kit TRQ PSA72516
$284.95
Replaces VW Audi Electric Air Pump Pierburg 7.22738.08.0
$256.03
Replaces VW Passat Audi A4 A4 Quattro A6 S4 Front 12 Piece Steering & Suspension Kit TRQ PSA58996
$254.95
Replaces VW Audi Front 8 Piece Control Arm with Ball Joint Set TRQ PSA62593
$244.95
Replaces 2001 VW Passat Front Wheel Drive Rear 2 Piece ABS Wheel Speed Sensor Set Delphi DEBCK00027
$242.95
Replaces VW Passat Audi A4 A4 Quattro Timing Belt Kit with Water Pump Gates TCKWP306AM
$240.95
Replaces VW Audi Front 10 Piece Suspension Kit TRQ PSA76076
$236.95
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out. Next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video I'm going to show you how to service a tail light, both changing the bulbs as well as changing the entire tail light if you break one. This is a 2001 Passat, which is the earlier style for 2001, and it works for 1998 to 2001. The only tool you'll need is either an 8mm wrench or a socket with a ratchet.
To service the tail light on one of these vehicles you can come around to the trunk. On the passenger side, if you've never serviced it before, you might have to break away, there will probably be a perforation to break away. Pull this door out. Once you have that out, then you can see right back in here the tail light connector plate. Pull that out. If you're just looking to service the bulbs, pull them out counterclockwise and put them back in.
If you need to replace the whole tail light assembly, then there's three 8mm bolts. There's two on the outside, one there and one there, and then one on the inside right there. You just reach in with an 8mm wrench. Once you loosen the nuts a little bit they tend to twist right off with your fingers. You're just going to do that for all three. Once those are undone, and the light sticks a little bit, it comes right out. Here's the new replacement from 1A Auto. Even though my original one was fine I just want to show you this, makes a great replacement. It's going to bolt right in if you've broken your tail light. I get it in. Make sure you've got all the studs lined up. Then start your nuts on.
I'm going to kind of hit fast forward here. All I'm doing is reaching in there and starting those 8mm nuts on to the studs, basically hand tightening them, and then reaching in with my wrench and tightening them up firm. You don't have to have them extremely tight, but they need to be tight enough to press the sponge seal to the body.
Once you get that you can put your plate back in, top up in first. Make sure the bulbs go in. Press it right in. Then you just put this back in place. Here on the other side, take this panel out. Reach back in here. Feel for the larger tabs; squeeze them. Pull your plate out. Then you're going to have to just manipulate it around a little bit. Push it down and then kind of back up and out. Again, you get to your plate just like before. Just back down in. Get that lined up and back in.
We hope this helps you out. Brought to you by www.1AAuto.com. Your source for quality replacement parts and the best service on the internet. Please feel free to call us toll free: (888) 844-3393. We're the company that's here for you on the internet and in person.
