Replaces
Frequently bought together
Part Details
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
What's up guys? I'm Andy from 1A Auto. In this video I'm going to show you how to replace the rear outside door handle on this 2001 BMW 325 XI. If you need parts for your vehicle, click the link in the description. Head over to 1AAuto.com.
Open the door. I'm just going to grab a straight blade pocket screwdriver just to take this little trim piece off. Just a little cover, just a little rubber cover. I'm going to take a hex key number 4, that's 4 millimeter, and there's a bolt or a screw right there. You go in at that angle. Loosen this up. As we're loosening this up, this cover right here is going to come loose, so keep wiggling it back and forth. All right, make sure that's unthreaded all the way. Slide this out.
It's a little bit of a struggle so you can use a trim tool. Just get down underneath here. Just be careful not to scratch the paint. Here we go. Pull that off, slide that out of the way. Once that cover is off, then you can actually take, there's a screw in there that you're going to use a T15 driver. It's easier to use a driver than actual bits because you'll be able to get in there, and you're going to go over here. You're going to loosen this up. It's kind of a reverse thread. As I loosen it, the pin is going to go in, it's going to loosen up, and then you'll be able to slide the handle just like this, and then grab the handle and slide it outwards.
Take the door handle, we want to slide this into this side of the door here first. with that in, then we position this over here. Make sure you have the gasket is on, especially if you're replacing the door handle. Line this up, slide that like that. Take the T15 driver. We're going to slide it in the hole down here and then you're going to turn it clockwise, which is actually going to pull that pin back through the door handle. Not too tight. You don't want to break anything. You can recheck the door handle and make sure it's working. We can actually close the door, try it. That is working properly. Now take this cover, slide this back in position, just like that. Take the hex key, line up the screw, push that down, and then just snug this up. That's good. Take this little plug, put it back in position. You're good to go.
Thanks for watching. Visit 1AAuto.com for quality auto parts shipped to your door, the place for DIY auto repair. And if you enjoyed this video, please click the subscribe button.
