Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace a power window switch on this 2003 Chevy Monte Carlo. We show you on the driver's side, but the passenger side is the same procedure. The items you'll need for this is a new power window switch from 1AAuto.com, a flat blade screwdriver, a Phillips screwdriver, a T25 Torx driver, and a putty knife.
Your door panel is held on with four screws. There's a Phillips screw here and a Phillips screw up here. Then down here, onto the pole handle, there are two T25 Torx screws. We'll just fast forward as Mike removes those. Pry out, behind this panel, the flat blade screwdriver, and then slide the panel forward and over the door handle. Then pry out on both sides of your door lock switch while pulling up on it. It should pull free.
There's an indent right here that you want to slide your putty knife into, and then just pry out on the clip. Then reach back behind the door panel and feel for the clips, and just pull out sharply to release the clips. Once you've release them all the way around, just lift the door panel up and then pull it back. Push the tab on this harness and pull it free. Do the same thing for this harness. Your door panel is free.
On the back of your door panel, you want to remove the three Phillips screws that hold on this plate. Now, in the front of the door panel, remove this Phillips screw. We'll just fast forward as Mike does this. That inside of your pull handle will pull down and out, and then you just want to push in this clip with a flat blade screwdriver, push up on the panel, and do the same here. Then this one can be a little bit more difficult, so just stick the screwdriver in there, push on it, and then pull the screwdriver out. Then do this tab on the other side of the switch. Just keep pushing it out and your switch panel will pull free.
Now, on the back of your switch panel, just pry out on these two tabs while applying pressure on the other side of the switch. Then just push back on these two tabs while pulling the switch free. Take your new switch and push it into the switch panel. Push the outside of the switch panel in first, then the front from the inside. Then push down the back of the panel last.
Replace the inside of your pull handle and that Phillips screw. Replace this plate and the three Phillips screws that hold it into place. To reconnect your door panel, just start off by reconnecting these two harnesses. Then just put this switch through here, then line up these slots with these four tabs, and just lift the door panel up, and push those slots onto the tabs. Then just make sure the clips are lined up and hit them into place along the sides of the door panel. Now, push your door lock switch back into this panel, slide the panel over your interior door handle, and slide it back into place. Then just replace those four screws, and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.