Replaces
Frequently bought together
Complete Repair in One Purchase - Stop searching for parts individually and complete your repair with a customized kit or set from DIY Solutions.
High-Quality Parts from Trusted Brands - DIY Solutions' kits and sets are selected from the best automotive brands and include hard-to-find and even obsolete parts you may need for your vehicle.
Guaranteed Fit - DIY Solutions ensures its selected parts are quality-tested to guarantee fit and function.
Install Tip: Keep & reuse your original hardware, new hardware is not included with this item.
Item Condition:
New
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi, I'm Mike from 1AAuto. We've been selling auto parts for over 30 years! We're dedicated to delivering quality auto parts, expert customer service, and fast and free shipping, all backed by our 100% satisfaction guarantee. So visit us at 1AAuto.com, your trusted source for quality auto parts.
We took the wheel off to get a better camera angle, but you probably don't need to in your driveway. You just need to turn the wheel to the right so that you can access the three Torx bolts that are right on the inner fender liner. They're T20 bolts, and you'll want to remove those along with the two clips on the top of the fender liner so that you can push the liner out of the way.
With the trim tool that you can get from 1A Auto, you can pop it right in the clip and pull the clip right out of the fender liners. Once you have the centers out, the bottom half will come out very easily, just like that. There's one more clip right here on the back on the inner wheel well. You'll pop out the center and then the bottom half and the fender liner should be loose at that point.
The first step in replacing the fog light is removing the bezel that's on the outside of it. To do that you need to release the clips; there's five of them around the outside housing. You just basically take a small, flat tip screwdriver. You can pry in these little plastic tabs and pull them out. Then you can push down on the bezel and the bezel clips will pop right out. Once they're released you should be able to pull the bezel right out of the bumper.
The bezel you're going to put the large side to the inside edge of the bumper, and it just pushes right into place. It has a couple of snaps, has five snaps around the outside edge that you'll want to double check that they click on in the backside of the bumper. As soon as they snap in, it's installed.
The last thing to hook up right here is the connector which again, it just pushes right into place. The long stud that's on the fog light actually has a Phillips head screw on the inside of it so all you do to adjust it is put a Phillips head screwdriver in it and turn it and it will adjust it on the bumper side.
The fender liner can now be put back into place. Tuck it behind the ABS sensor wire and then start putting your push pins right back into place. You'll want to reinstall your three T20 Torx screws next in the front of the fender liner.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
