Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Direct Fit - No vehicle or wiring modification necessary
DOT, SAE, and FMVSS Compliant - Meets on-road use regulations
Matching set for a restored look
Item Condition:New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
How to Replace Tail Light 2002-09 Chevy Trailblazer
Created on:
Tools used
Phillips Head Screwdriver
1. Remove the tail light assembly
Open the tail gate and remove the two Phillips screws.
Pull the tail light assembly out.
Disconnect the wiring harness from under the vehicle and remove the bulbs.
Service your bulbs at this point or put your bulbs in the new tail light assembly.
2. Install the tail light assembly
Plug in the bulbs and wiring harness.
Clip the tail light assembly into the vehicle.
Screw in the two Phillips screws
Close the tail gate.
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet. In this video we are going to show you how to change a taillight on this 2004 Trailblazer. It's the same for most Trailblazers and Envoys, as well the Bravada. Only tool you will need is a Phillips Screwdriver.
Start by removing 2 screws. And we'll speed it up here a little bit. Once you have those screws out you pull out on your lamp and it comes out pretty easy. There are two tabs here that go here. To disconnect your harness there is a little tab right here and it pulls off.
New light from 1A Auto, you can see it is all the same, it is nice and bright and shiny. This particular one comes with the connector plate. If on your vehicle all you are looking to do is change bulbs you need to remove 3 more Phillips screws. And again we will hit fast forward as I just remove those 3 Phillips screws. We will remove those and this plate comes out to switch these bulbs you just pull the bulb out and put it back in. Then obviously you put it back together.
And we'll fast forward again as I put those 3 screws back in. Now to show you the new light from 1A Auto plugs in exactly like the original. Get back in here and you can kind of look right down and see where your pins are going into the tabs there. Push it on.
We hope this helps you out. Brought to you by www.1AAuto.com your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll free 888-844-3393. We are the company that is here for you on the Internet and in person.
LTA87955
In Stock
Product Reviews
Loading reviews
There are no reviews for this item.
Customer Q&A
No questions have been asked about this item.
Customer service
877-844-3393
Monday - Friday 8:00am - 9:30pm ET Saturday - Sunday 8:00am - 4:30pm ET
Chevrolet is a registered trademark of General Motors Company. 1A Auto is not affiliated with or sponsored by Chevrolet or General Motors Company.See all trademarks.
Enter Vehicle Year Make Model
Specify your vehicle's year, make and model to guarantee fit.
Year
Make
Model
Options
Drivetrain
This part doesn’t fit a . Select from parts that fit.