Replaces
Frequently bought together
Is your rear back glass not staying open anymore? The problem could be the lift supports mounted to the glass. These get weak over time and require replacing. No need to lose money at the dealer for this simple do it yourself replacement. Our lift supports are just what you are looking for to get your tailgate glass to stay up again.
Specifications:
This is for one support. We recommend replacing them in pairs.
Install Tip: Keep & reuse your original hardware, new hardware is not included with this item.
Item Condition:
New
Attention California Customers:
WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the rear hatch support pistons on this 1996 Chevy Tahoe. This is pretty much the same for any Tahoe, Yukon, Yukon XL, or Suburban that has the rear tailgate and lifting rear glass. We're going to show you on the left side, but the right side is the same procedure. We do recommend you do this in pairs. You'll need new support pistons from 1AAuto.com and a small flat blade screwdriver, as well as somebody or something to hold up the glass while you're doing the repair.
There's just clips that go around the end. You pry the clip out with a small screwdriver. Again, have somebody helping you hold it up. Pry the clip out. Pull the piston off, and then do the same thing for the other end. Here, you can see there's the original one on top.
The new one from 1A Auto is on the bottom. It's going to install just the same as the original. Put the piston and push it onto the stud. Then you might have to turn it a little bit to get it to line up. Push the other end on, do the other side, and you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
