Replaces
Frequently bought together
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Don from 1A Auto. I hope this how-to video helps you out, and the next time you need a part for your vehicle, think of 1AAuto.com. Thanks.
In this video, we're going to show you how to replace the blower motor resistor on this 2002 Chevy Suburban. The items you'll need for this include a 7mm socket and ratchet, 7/32" socket, and a flat blade screwdriver.
We're going to start off by removing this panel below your glove box, and it's held in with these three 7mm bolts. We'll just fast-forward as Don removes those. And you really only have to remove the two on the outside. The one towards the center of the vehicle, you can just loosen.
Now, your resistors held in with two 7/32" bolts. Just go ahead and remove those, then push the tab on this harness, and disconnect it. Up here on your blower motor is the other end of your resistor harness. You want to just push the tab on this and disconnect it.
Take your new resistor, reconnect this harness, feed it back up into place, and replace those two 7/32" bolts. We'll fast-forward as Don tightens those up. Now, reconnect your resistor harness. Push this panel back up into place, replace those three 7mm bolts, and just tighten them up. We'll fast-forward as Don does this. Once you've done that, you're all set.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
