Replaces
Assemblies may include halogen or incandescent test bulbs that should be replaced before installation.
Features and Benefits
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Chromium (Hexavalent Compounds), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
The bulbs are for testing and not covered under our warranty. Our warranty applies to the light assembly only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
In this video we're going to replace the fog light on this 2004 Chevy Trailblazer, same as any '02 to '05. The only tool you'll need is a 10mm wrench or a socket with a ratchet.
For a fog light for one of these vehicles, you're going to want to come up underneath. I've got the car on a lift, but that's not necessary at all. You can see I have easy access to it. If all you're looking to do is change your bulb, you may want a screwdriver, but you can kind of reach in there with your finger and pull your lead off, and your bulb actually just twists counterclockwise here. Actually, quite honestly, it's easier with your leads still plugged in. Pull the bulb out. My bulb is fine; so I'm just going to show you. You remove the bulb and then when you go on to put it back together, I'd put the bulb back in. You don't want to touch the bulb; it's halogen. Oils from your hand could cause it to burn out quicker. Twist the bulb in and plug it back in.
If you're looking to do the whole fog light, you just need a 10mm socket with a ratchet. There are three 10mm bolts. We'll fast forward here as we just remove those three nuts. It pulls right out the front.
This is the original light and often these get wiped out by rocks and stuff. See the new light from 1A Auto is nice and clear. They'll bolt in the same way. We'll hit fast forward again as we put the three nuts on by hand and then tighten them up with a 10mm wrench. You don't have to make them extremely tight, but they need to be nice and firm. Plug the cord back in, and there's the new light installed. Quite a bit brighter than the old milky lights.
We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
