Replaces
Frequently bought together
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including 1,3-Butadiene, which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Brought to you by 1AAuto.com, your source for quality replacement parts and the best service on the Internet.
Hi, I'm Mike from 1A Auto. I hope this how-to video helps you out, and next time you need parts for your vehicle, think of 1AAuto.com. Thanks!
In this video, we're going to show you how to replace the thermostat and housing. This is a 2008 Dodge Ram with a 5.7 liter. You'll need a drain bucket, flat-head screwdriver, 13 mm socket, ratchet, and extension, as well as extra engine coolant. This can easily be done from the ground, but we raised and supported our vehicle and put a drain bucket under our radiator.Open the drain on the bottom of the radiator. Drain the radiator down enough so that you won't get any fluid coming out when you take off the radiator hose. Then also close your drain when you're done draining it.
Your upper radiator hose runs from the top driver's side of the radiator to the top driver's side of the engine. Disconnect the clamp on the engine side with a flat-head screwdriver. It appears that on this vehicle the hose is already replaced, so it has these screw style clamps. You may find that you have clamps that you use pliers, such as this style. Slide your clamp out of the way and remove the hose from the engine.
Remove the two 13mm bolts that hold the thermostat housing to the water pump. Remove your thermostat housing from the water pump. Using a flat-head screwdriver, pry the thermostat out of the water pump.
Before installing your new thermostat, ensure that your part has a new gasket on it. This is the only seal on the thermostat. There's no gasket around the bottom of the housing. Reinstall your thermostat housing and your two 13 mm bolts.
Reinstall your radiator hose onto the thermostat housing. Tighten down your clamp with a flat-head screwdriver.
Remove the radiator cap by pressing down and, turning counterclockwise two clicks. Fill your radiator with Mopar approved 50/50 coolant.
Any time you drain the coolant from your vehicle, you're going to want to properly bleed the system. To do this, fill your radiator and your expansion tank. Turn the heat on in your vehicle and let it run.
With the cap off, wait until you see all the air bubbles come out, constantly checking the fluid level until the fluid level remains stable without any bubbling or draining. Then you're safe to reinstall the cap.
Ensure that your heat's blowing hot air. You're ready to go.
Thanks for tuning in. We hope this video helps you out. Brought to you by www.1AAuto.com, your source for quality replacement parts and the best service on the Internet. Please feel free to call us toll-free, 888-844-3393. We're the company that's here for you on the Internet and in person.
