Replaces

Lexus RX350 Driver & Passenger Side 2 Piece Liftgate Lift Support Set TRQ GSA04209

$ 339.95

$461.95

26% OFF

$461.95

26% OFF

FREE SAME DAY SHIPPING

GSA04209

In Stock

This part doesn’t fit a . Select from parts that fit.

Show parts that fit

Orders must be placed by 2pm ET

1A Auto Lifetime Warranty

Description

Vehicle Fit

Warranty & Shipping

Part Details

Kit Includes:
(1) Passenger Side Liftgate Lift Support
(1) Driver Side Liftgate Lift Support
Quantity: 2 Piece

Item Condition: New

Attention California Customers:

proposition 65 icon WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Product Reviews

Loading reviews

Customer Q&A

is there special tool needed?

November 14, 2023

Hoang N

No. Any small flat head screw driver or even a metal pick will pop off the metal rings. New ones/struts snap back on without tools.

November 23, 2023

Kwang K

You may need a small screw driver to get the locking pin out and a mallet to lightly tap the strut out out of the ball joint.

November 29, 2023

Corey M

you need a small screw driver to remove the clips. I used a rubber mallet to tap them on

December 6, 2023

ROGER F

Do you have an installation video? is there special tool needed?

November 15, 2023

Hoang N

is there instruction to replace 18 Lexus rear hatch struts?

November 15, 2023

Hoang N

Chris, the mounting clips look like the clips on the hood struts for my new to me old Dodge P/U. In my case I used a small flat blade screwdriver to pop the clip off and the strut easily pulled off the fixed receiver ball and I pushed the new part on the fixed ball popped the new clip in place. It worked well on all four points. When I started, I was prepared for an hour +/- and plenty of profanity. I was in and out in 15 minutes and no cursing. Tools: small flat bladed screwdriver, slip joint pliers, a scratch awl (to get under the clip at first) and a broom stick. Tools used: Small screwdriver and broomstick. Hope this helps. David

November 16, 2023

David P