Replaces
Frequently bought together
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Highest Quality MaterialsMade from highest quality materials that meet or exceed OEM standards
Quality Tested - built to a strict level of product standards.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
Hi. I'm Mike from 1AAuto. We've been selling auto parts for over 30 years!
The blower resistor is located up near the firewall and held in with two Phillips head screws, and the electrical connection. It's hard to get my fingers in there to hold the lock, so I'm going to use a small flat-bladed screwdriver. Push the lock in. Get the connector out.
It's really hard to see where the lower screw is. I’m just kind of doing it by feel. There it is. Get that screw in there. Get that screw loose. I'm going to grab onto the blower resistor, and pull it right out. Have to wiggle it past that little black piece, and then we can pull it right out.
So here's your blower motor resistor. There are little fins in there to cools off the electronics. Plastic cover piece. It's only going to go in one way, so this would be the top, and this is the bottom, because the push connector was on this part.
I'm just going to reach up and reinstall it. I’m going to install the upper screw. It’s easier to see. Get this one started. It's just self-tapping, so it's going to go into plastic. As soon as you feel it gets tight, you can stop, and install the bottom one in. I’m going to reinstall the electrical connector. It'll snap, and it's locked in place.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
