Replaces
Frequently bought together
Left Hand Drive:
All of our auto parts are intended for Left Hand Drive USDM vehicles. If your vehicle is Right Hand Drive, please ensure the part is correct for your specific vehicle.
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl)phthalate (DEHP), which is known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Returns: Parts with electrical components cannot be returned once installed.
FREE Shipping is standard on Orders shipped to the lower 48 States (Contiguous United States). Standard shipping charges apply to Hawaii, Alaska and US Territories. Shipping is not available to Canada.
Expedited is available on checkout to the United States, excluding Alaska, Hawaii and US Territories as well as P.O. Boxes and APO/FPO/DPO addresses. Final shipping costs are available at checkout.
Created on:
Tools used
What's up guys? I'm Andy from 1A Auto. Here I have this blower motor I'm going to show you how to install on this 2010 Toyota RAV4. If you need this part or other parts for your vehicle, click the link in the description and head over to 1AAuto.com.
I want to remove this panel right here. This is underneath the passenger side. Just use a straight blade screwdriver or you could try to push down on these tabs, those lock tabs. It's just easier to use a screwdriver. Oops. And just like that. And then it slides out. There's a little pin right there.
I'm going to disconnect the resistor connector right here. Just push this little tab right there and pull the connector down.
There's a wire retainer right there, and just slide that down. This just get the wire out of your way. And then disconnect the connector on the blower motor. There's a little lock tab. Push in on that lock tab and try to get the connector out. Just like that. Got it out.
Now, I want to take these screws out. I'm going to use a T25 extension and a ratchet. There's one here, one here, should be one around here somewhere. All right, so I'll take those out. I'm going to use an electric ratchet, but you can just use a hand ratchet.
Last one's right there in the front. You can grab it and just slide it down.
Here's the old part. Here's the new blower motor from 1AAuto.com. As you can see, the shape is the same, the height is the same, has the same exhaust port right there. Flip it over. The connector is the same. It's got the same shape and same mounting positions. Get yours at 1AAuto.com and you'll be ready to rock and roll.
So how this blower motor mounts, it's this little extra port right here, which is like an exhaust port. It goes towards the middle of the car, right here. So that's going to fit in right there. So it's a key way so that everything lines up.
Take these three screws, get these all started. And get that one started. And then this back one.
All right, those are all secure. I'm just going to tighten these down.
Use my T25. Just snug, not too tight. It is in plastic, so be careful.
And this last one. That's good.
All right. Take this electrical connector, line it up in position, and lock it in place. And then this wire retainer, it's going to attach to a little tab right here, behind the blower motor. Right there.
Take the connector, plug the resister back in. Reinstall this lower cover. Just slide this pin through that hole right there, and line these two retainers through the slot, lock it in place.
Thanks for watching. Visit 1AAuto.com, your place for DIY auto repairs, for great parts, great service, and more content.
