Replaces

2013 Subaru Legacy H6 3.6L Upstream Right O2 Oxygen Sensor TRQ OSA60404

$ 49.95

$67.95

26% OFF

$67.95

26% OFF

FREE SAME DAY SHIPPING

Read 1 REVIEWS

OSA60404

In Stock

This part doesn’t fit a . Select from parts that fit.

Show parts that fit

Orders must be placed by 2pm ET

1A Auto Lifetime Warranty

Frequently bought together

O2 Oxygen Sensor TRQ OSA60404

$49.95

OBD2 Diagnostic Scan Tool

$51.95

Description

Vehicle Fit

Warranty & Shipping

Part Details

Wrench Size:
22 mm
0.87 in
Thread Diameter:
18 mm
0.71 in
Universal Or Specific Fit: Specific
Wire Quantity: 4
Connector Gender: Male
Terminal Type: Blade
Overall Length:
9.06 in
230 mm
Thread Size: M18x1.5-6e
Connector Shape: Square
Mounting Type: Threaded
Terminal Gender: Male
Sensor Type: Heated
Band Type: Wide
Wiring Harness Length:
4.41 in
112 mm
Sensor Design: Planar
Terminal Quantity: 4
Grade Type: Regular

Specification

Oxygen Sensor Location

Upstream Right

Engine Displacement (Metric)

H6 3.6L

TRQ oxygen sensors are manufactured to precise specifications using premium raw materials to optimize your vehicle’s emission system. Each sensor is isostatically-pressed for improved strength and durability, and plasma-sprayed to improve sensitivity and prolong the service life of the sensors. Oxygen sensors wear out over time and should be replaced every 60,000 miles to prevent poor engine performance. TRQ recommends replacing the oxygen sensors in sets to optimize fuel economy and reduce overall emissions. All products are fit and road-tested in our Massachusetts R&D facility to ensure we deliver on our promise of Trusted Reliable Quality.

Product Features

Application Specific Design: No modifications and pre-calibrated

Isotatic-pressed and plasma-sprayed for extended service life

Double-Layered 310S Stainless Steel: Additional protection from moisture and debris

Restored Engine Performance: Improved fuel economy and lower emissions

What is Upstream vs. Downstream?

Upstream location is between the catalytic converter and the engine
Downstream location is between the catalytic converter and the tailpipe

Install Tip: You may be required to reset the vehicle computer after installation of this part.

Item Condition: New

Attention California Customers:

proposition 65 icon WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.

Lifetime Warranty

This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.

Returns: Parts with electrical components cannot be returned once installed.

Product Reviews

Loading reviews

5.00/ 5.0

Mark

Needed to replace two O2 sensors. Folks at 1A Auto were helpful in making sure I was getting the right product for my 2013 Subaru Outback 3.6. I had a time crunch and the parts arrived as promised. Installation was a snap--way easier than I had anticipated. A little PB blaster the night before, another spray in the AM, and within 45 minutes--with the proper tool I got from 1A--the old sensors were out and new ones were in. My diagnostic lights came back on after a little driving, but I erased the codes, then reset ECM and they went away. Took an 1,800 mile road trip after and everything went great. Quite a bit of smoke after new sensors were installed as the engine had been running rich, but that burned off. I'd recommend if you've got this issue to order some fuel system cleaner, too as you'll have gunk in your system that needs to be cleaned. After a tank of gas, my MPG had improved substantially.

Customer Q&A

No questions have been asked about this item.