Replaces
Frequently bought together
Item Condition:
New
Attention California Customers:
WARNING: This product can expose you to chemicals including Lead and Lead Compounds, which are known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information, go to www.P65Warnings.ca.gov.
Lifetime Warranty
This item is backed by our limited lifetime warranty. In the event that this item should fail due to manufacturing defects during intended use, we will replace the part free of charge. This warranty covers the cost of the part only.
Created on:
Tools used
Hi, I’m Mike from 1A Auto. We’ve been selling auto parts for over 30 years!
In this video, we will be removing and reinstalling a washer fluid pump in a 2010 Volkswagen GTI. We're going to take these T25s out of the front grille. We're using a T25 socket extension and a ratchet. Then, going to grab underneath the grille and just pull forward. There's little clips underneath. That came out easy. You may have to work at it a little bit. I'm going to pull this panel off. Grab underneath and pull. We have a T25 that goes straight up and down. I'm going to use our T25 socket and extension. Get on it. There's two more down here. We're going to pull our connector for our fog lights. You're going to push on this little tab here and then pull down. The connector will pull right out. Push down and pull that straight out.
The driver's side is the same. On the driver's side, the wiring harness had a retainer that's attached to the bumper. You're going to pull it straight out. We're going to take out all these T25s. There's one here, one here, one there, one there, one there, one there, these two, and these two. Now, on both sides, I'm going to grab right here and pull out. I'm going to take these last two out and we'll pull straight forward.
You’re going to want a bucket or something to catch the fluid when you pull this off, but we'll pry this little guy up with a flat blade tool just like that so it's up and that pulls off. Do the same with the other side. Pull that one off. Grab up here the connector high up on the connector and then pull. To get the pump out, you're going to pull straight up.
To install, we're going to take and line it up. Push it straight down. We're going to connect our connector until it clicks. We're going to take this hose, pop it on there. Push the white tab down. That's the lock. Then, connect this hose to this side. Push down the black lock.
For ease of installation, it's easier if you have a partner when taking it off and can line it up. Install these two T25s. I'm going to install these T25s. Next, we're going to connect the marker light and push that in. Now, we're going to connect the fog light. Just push it on till it's locked in. Do the same for the driver's side. Right. We're going to install this last. We're going to install this T25 going up. You're going to push on the bumper and make sure it lines up while you're tightening it and put these torque screws in. Install the cover. Put it in the top and push in.
Install the grille and line it up down below. And push to lock it into place. Install these four T25 torx screws.
Thanks for watching. Visit us at 1AAuto.com for quality auto parts, fast and free shipping, and the best customer service in the industry.
